21-P14 - 1/8" 3mm Fastcut Porcelain Bit
Blow through hard surfaces faster! Troxell FastCut Drill bit are designed to bore round holes in various types of porcelain, glass, ceramic, marble, and quartzite.
Installation & Safety Recommendations
• Use in all drills
• Apply water during drilling. This will extend
lifespan of bit.
• No tape, center punching or pilot holes
required: place the bit on the specified mark,
apply pressure, listen for a slight crunch and
start your drilling process
• For best results drill at 2,300 RPMs and slow
down when ready to complete the drilled hole
• Do not apply excessive pressure
• Do not use dull or damaged bit
• Not recommended for use in drill press or
hammer drills
